Table of Contents
Advertisement
Menu Items
3-18
Parallel menu
Acknowledge
Bi-direction
NPAP mode
Serial menu
Baud rate
Format
Flow control
Network menu
NPAP mode
BootP
IP address
IP netmask
IP gateway
Test menu
PCL config page
PCL font list
FPS config page
FPS font list
Clear warning
<Clear warning> print unit
The timing of the ACK signal against the
BUSY signal
Bi-directional Centronics interface mode
Whether the NPAP commands are used. When
using MarkVision, the NPAP mode must be
Auto or On.
Data transfer speed on the serial interface
Data format for the serial interface. The first
digit indicates the number of data bits. Then
comes the parity and the last digit indicates the
number of stop bits.
Interface protocol
Whether the NPAP commands are used. When
using MarkVision, the NPAP mode must be
Auto or On.
Whether the TCP/IP protocol that enables a
workstation to find its IP address is enabled or
disabled for the network adapter
A unique address of the printer in the TCP/IP
network environment
Bit mask that logically subdivides the network,
specifying a local network portion of the IP
address
A unique address of the equipment for the
gateway to outside of the enclosed environment
Print a self-test report using PCL emulation
Print a list of fonts available in PCL emulation
Print a self-test report using FPS emulation
Print a list of fonts available in FPS emulation
Clearing the print unit counter
User's Manual
Advertisement
Table of Contents
