Fujitsu 10 ppm User Manual page 23

Setting Up
1-8
To prepare the print unit and install the toner bottle, follow these steps:
e
w
q
Projecting guide
1. Open the upper door. Lift
the milled portions at the
front left and right of the
upper door to open it.
2. Remove the protective
materials from the print unit.
Remove protective sheet q.
Pull clear tape w until its
blue end is visible and remove
it. Remove two restraint
cushions e.
3. Remove the toner bottle
from its bag.
4. Shake the toner bottle by
moving it back and forth in
a horizontal motion several
times.
5. Remove the plastic seal
from the toner bottle.
Gently pull off the seal being
careful not to spill toner.
Handle to seal carefully to
avoid staining your hands or
clothes.
User's Manual