Table of Contents
Advertisement
User's Manual
Message
MOTOR FAILURE n
NO PROCESS UNIT
OVERRUN ERROR
PAPER JAM n
PS ERROR mn
Source PAPER OUT
STACKER FULL
SYSTEM ERROR n
TRAY n MISS SET
TONER EMPTY
Causes and solutions
Cause: Malfunction in the feed motor, etc.
Solution: If the error recurs, consult your
dealer for service.
Cause: No print unit is installed.
Solution: Install the print unit.
Cause: Incomplete in extracting
compressed data
Solution: Press the
CONT.
Cause: Paper jam in the specified position
Solution: Clear the jammed paper from the
following area:
0: Pick roller, 1: Entry to paper path
2: Paper path, 3: Ejection from paper path
Cause: A PostScript error
Solution: If the error recurs, consult your
dealer for service.
Cause: Paper out in the specified paper
source
Solution: Supply paper.
Cause: Paper stacker full
Solution: Remove paper from the paper
stacker.
Cause: A system error on the controller
board
Solution: If the error recurs, consult your
dealer for service.
Cause: Paper tray installed incorrectly
Solution: Install the paper tray.
Cause: Toner runs out.
Solution: Replace toner bottle.
Error Indications
button.
SOLVING
PROBLEMS
6-13
Advertisement
Table of Contents
