Installing The New Print Unit - Fujitsu 10 ppm User Manual

10/14 ppm page printer
Table of Contents

Advertisement

Periodic Routine Maintenance
Clear tape
w
5-10

Installing the New Print Unit

Notice:
To avoid exposing the photoconductor drum to light or
contamination, follow these guidelines:
• Do not remove the print unit from its envelope until you are ready
to install it.
• Complete the procedure as quickly as possible to avoid exposing
the drum to light for more than three minutes.
To avoid damaging the drum:
• Be sure to remove the plastic sheets after installing the print unit.
Operating the printer without removing the sheets will make the
print unit unusable.
• Never touch or scratch the green drum surface.
Print unit
Green drum
• Be careful not to allow dust or foreign matters into the toner
hopper.
To install the new print unit, follow these steps:
q
1. Remove the print unit from
its envelope. Place the unit
on a level, steady place.
2. Remove the protective
materials from the print
unit. Remove protective sheet
q. Pull narrow clear tape w
until its blue end is visible
and remove it.
User's Manual

Advertisement

Table of Contents
loading

This manual is also suitable for:

14 ppmPrintpartner 10vPrintpartner 14v

Table of Contents