Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Fujitsu fi-760PRB
Summary of Contents for Fujitsu fi-760PRB
- Page 1 P3PC-6112-01EN fi-760PRB Imprinter Operator’s Guide...
-
Page 2: Table Of Contents
Contents Introduction..........................2 Chapter 1 Preparations......................4 Checking the Package Contents....................4 Names of Component Parts......................4 Chapter 2 Installation......................6 Installing the Imprinter.......................6 Loading the Print Cartridge .......................8 Test Print..........................10 Chapter 3 Basic Operation ....................12 Setting the Print Position......................12 Using the Paper Guides......................12 Print Setup ..........................14 Replacing the Print Cartridge....................14 Removing Jammed Documents....................16... -
Page 3: Introduction
Introduction Thank you for your purchase of the fi-760PRB Imprinter. Abbreviations Used in This Manual The fi-760PRB Imprinter is an optional unit to be used The operating systems and products in this manual are with the fi-7600 image scanner. indicated as follows. - Page 4 Arrow Symbols in This Manual Right-arrow symbols () are used to separate icons or menu options you should select in succession. Click [Start] menu [Control Panel]. Screen Examples in This Manual Microsoft product screenshots are reprinted with permission from Microsoft Corporation. The screen examples in this manual are subject to change without notice in the interest of product development.
-
Page 5: Chapter 1 Preparations
(Feeder) Document Feeder) included in the package. If anything is missing or damaged, contact your FUJITSU scanner dealer or an authorized FUJITSU Stacker scanner service provider. Use this product and accessories carefully. 1.2 Names of Component Parts ■... - Page 6 ■ Inside Paper Guide Print Cartridge Cover Print Cartridge Holder...
-
Page 7: Chapter 2 Installation
Chapter 2 Installation 2.1 Installing the Imprinter Look into the scanner from below to check the position of the bar. Install the imprinter as follows: ATTENTION Do not move the scanner with the imprinter installed. The imprinter may be damaged. Turn off the scanner power and disconnect the Align the attachment guide with the bar. - Page 8 ATTENTION Confirm the following after attaching the attachment guide. The attachment guide is not tilted. The attachment guide is fitted in the scanner, and not overhanging. Good: The attachment guide is properly attached. Bad: The attachment guide is tilted. After Installation Bad: The attachment guide is overhanging.
-
Page 9: Loading The Print Cartridge
2.2 Loading the Print Cartridge Turn the locks inside (two locks on the back side). Load the print cartridge as follows: ATTENTION When installing the print cartridge, install it properly. When you do not use the imprinter for a long time, remove the print cartridge from the imprinter. - Page 10 Remove the protection tape on the print cartridge. Move the print cartridge to an appropriate printing position. The print cartridge should be positioned within the section where the document will pass through. ATTENTION Do not touch the metal part of the print cartridge nor put the Close the print cartridge cover.
-
Page 11: Test Print
2.3 Test Print Select [1: Single Sheet Only] or [2: Multiple Sheets] by pressing the [ ] button or the [ ] button, and After loading the print cartridge, check if the printing then confirm the selection by pressing the [Scan/ operation works normally. - Page 12 Select [1: Yes] by pressing the [ ] button or the ] button, and then confirm the selection by pressing the [Scan/Enter] button. The blank sheet is fed into the scanner, and the imprinter will print out a print test pattern leaving a 5 mm gap (with an allowance of 4 mm inwards or outwards) from the edge of the document.
-
Page 13: Chapter 3 Basic Operation
Chapter 3 Basic Operation 3.1 Setting the Print Position 3.2 Using the Paper Guides Set the print position in the following steps: When documents have curled edges like below, use the paper guides to prevent paper jams. Open the print cartridge cover. Move the print cartridge to an appropriate printing position. -
Page 14: Attaching The Paper Guides
Push the head of the paper guide until it fits in well. HINT When you want to perform a print on the left or right margin of a wide document, the paper guide may get in the way. In this case, remove the paper guide and attach it to a place near the center where space is available ( ). -
Page 15: Print Setup
3.3 Print Setup 3.4 Replacing the Print Cartridge You can configure settings for the imprinter by using the The print cartridge is a consumable. scanner driver's setup window. Replace the print cartridge as follows: ■ PaperStream IP (TWAIN) (Example) ATTENTION ... - Page 16 Remove the old print cartridge. Bring down the arm of the print cartridge holder down gently until it locks in and set the print cartridge in place. Make sure that the catches (both sides) on the arm latch onto the print cartridge firmly. Catches Remove the protection tape on the new print cartridge.
-
Page 17: Removing Jammed Documents
3.5 Removing Jammed Documents Reset the ink counter in the following procedure. If a document jams, remove the jammed document as ATTENTION follows: Be sure to reset the ink counter after replacing the print cartridge. ATTENTION Open the ADF and the print section to remove the Display the [Software Operation Panel] window. - Page 18 Close the ADF. Print Section Hold the middle part of the print section, and close it as shown in the figure. ATTENTION Make sure that the ADF is closed before you close the print section. Be careful not to get your fingers caught.
-
Page 19: Chapter 4 Daily Care
Chapter 4 Daily Care 4.1 Cleaning the Print Cartridge 4.2 Cleaning the Imprinter Ink stains stuck to the nozzle plate of the print cartridge While you use the imprinter frequently, ink sticks to the or leaving the imprinter unused for a while may cause print cartridge holder base which makes the paper dirty. -
Page 20: Cleaning The Rollers
When cleaning, be careful not to touch the metal safely, read the precautions on each product wheels located at the print section. thoroughly. For information about the cleaning materials, contact your FUJITSU scanner dealer or an authorized FUJITSU scanner service provider. -
Page 21: Chapter 5 Error Messages
2. Check if the print cartridge is installed correctly. 3. Turn the scanner off then back on. If the problem persists, write down the displayed error code and contact your FUJITSU scanner dealer or an authorized FUJITSU scanner service provider. Imprinter error (print head) An error occurred in the imprinter. -
Page 22: Chapter 6 Specifications
Chapter 6 Specifications Item Specification Thermal inkjet printing Printing Method Post printing, back surface printing Print Timing Alphabet: A to Z, a to z Printing Characters Numeric characters: 0, 1 to 9 Symbols: ! " # $ % & ' ( ) * + , - . / : ; < = > ? @ [ ¥ ] ^ _ ` { | } ¯ Maximum of 43 digits Maximum Number of Characters per... - Page 23 Item Specification Temperature: 10 to 35°C (50 to 95 °F), Humidity: 20 to 80% Ambient Condition Print cartridge (PART No.: CA00050-0262) (See "Contact for Purchasing Consumables or Cleaning Consumable Materials" (page 23).) The printable number of characters: 4,000,000 characters (The printable number of characters differs depending on the characters to be printed.) Replacement cycle: 4,000,000 characters or six months after opening (A print cartridge has a specific expiration date, and the expiration period differs whether the package is opened or...
-
Page 24: Contact For Inquiries
If the solution to your problem cannot be found on the above web page, refer to the contact information for your Fujitsu office on the following web page: http://imagescanner.fujitsu.com/warranty.html Contact for Purchasing Consumables or Cleaning Materials http://www.fujitsu.com/global/shop/computing/... - Page 25 Imprinter Operator's Guide P3PC-6112-01EN Issue date: June 2017 Issued by: PFU Limited The contents of this manual are subject to change without notice. PFU Limited assumes no liability for incidental or consequential damages arising from the use of this product, and any claims by a third party.