Installing The New Print Unit - Fujitsu PrintPartner 12V User Manual

Periodic Routine Meintenance
4-10

Installing the New Print Unit

Caution:
To avoid exposing the photoconductor drum to light or
contamination, follow these guidelines:
Do not remove the print unit from its envelope until you are ready
to install it.
Complete the procedure as quickly as possible to avoid exposing
the drum to light for more than three minutes.
To avoid damaging the drum:
Be sure to remove the plastic sheets after installing the print unit.
Operating the printer without removing the sheets will make the
print unit unusable.
Never touch or scratch the green drum surface.
Print unit
Green
Be careful not to allow dust or foreign matters into the toner
l
hopper.
To install the new print unit, follow these steps:
I. Remove the print unit
from its envelope. Place
the unit on a level, steady
place.
2. Remove the protective
materials from the print
unit. Remove protective
sheer 1. Pull narrow clear
tape 2 until its blue end is
visible remove it.
and
User' s Manual