Fault Table - Hainbuch MAXXOS T211 Operating Instructions Manual

MAXXOS T211
Faults

13.2 Fault table

Fault
Defective axial
strokes in the
clamping device
Clamping element
cannot be
swapped in or out
Clamping force is
too weak
Clamping force is
too high
Geometry devia-
tion on the work-
piece
Possible cause Remedial action
Remove and clean the clamping
Dirt in the parts in element and, if necessary, re-
the power flow move, dismantle and clean the
clamping device
Defective drawtube
Discussion with the manufacturer
adapter
Incorrect drawtube Check drawtube position and align
position with the clamping device
Defective axial
See fault »Defective axial strokes
strokes in the
in the clamping device«
clamping device
Workpiece outside
the clamping width Use a suitable clamping element
diameter
Axial actuating
Check machine setting and cor-
force on drawtube
rect if necessary
too weak
Stroke limitation by
Use an appropriate workpiece
the workpiece end-
end-stop
stop
Incorrect lubrica- Check lubrication of the clamping
tion condition device and correct if necessary
Axial actuating
Check machine setting and cor-
force on drawtube
rect if necessary
too high
Axial run-out error Check axial run-out of the clamp-
on the clamping ing device and correct if neces-
device sary
Face run-out error Check face run-out of the clamp-
of the clamping de- ing device and clean the mating
vice surfaces if necessary
Remove the workpiece end-stop
Dirty end-stop area
and clean the mating surfaces
Dirty coupling area Remove the clamping element,
in the clamping el- clean the coupling area and the
ement clamping element
Dirty clamping ta- Remove the clamping element
per and clean the clamping taper
Order hotline +49 7144.907-333
Remedied by
Skilled special-
ist
Manufacturer
Skilled special-
ist
Skilled special-
ist
Skilled special-
ist
Skilled special-
ist
89