Table of Contents
Advertisement
MAXXOS T211
Faults
13.2 Fault table
Fault
Defective axial
strokes in the
clamping device
Clamping element
cannot be
swapped in or out
Clamping force is
too weak
Clamping force is
too high
Geometry devia-
tion on the work-
piece
Possible cause
Remedial action
Remove and clean the clamping
Dirt in the parts in
element and, if necessary, re-
the power flow
move, dismantle and clean the
clamping device
Defective axial
See fault »Defective axial strokes
strokes in the
in the clamping device«
clamping device
Workpiece outside
the clamping width
Use a suitable clamping element
diameter
See fault table on machine
Axial actuation
adapter [see operating instructions
force is too weak
for the machine adapter]
Stroke limitation by
Use an appropriate workpiece
the workpiece end-
end-stop
stop
Incorrect lubrica-
Check lubrication of the clamping
tion condition
device and correct if necessary
See fault table on machine
Axial actuating
adapter [see operating instructions
force is too high
for the machine adapter]
Check the concentricity of the
Axial run-out error
quick change-over system and the
on the clamping
clamping device, and correct if
device
necessary
Check top run-out on the quick
Face run-out error
change-over system and the
of the clamping de-
clamping device and, if required,
vice
clean their mating surfaces
Remove the workpiece end-stop
Dirty end-stop area
and clean the mating surfaces
Dirty coupling area
Remove the clamping element,
in the clamping el-
clean the coupling area and the
ement
clamping element
Dirty clamping ta-
Remove the clamping element
per
and clean the clamping taper
Geometry error on
the workpiece due
Use a suitable clamping element
to incorrect type of
clamping element
Order hotline +49 7144.907-333
Remedied by
Skilled special-
ist
Skilled special-
ist
Skilled special-
ist
Skilled special-
ist
71
Advertisement
Table of Contents
