Fault Table - Hainbuch MANDO Adapt T212 Operating Instructions Manual

MANDO Adapt T212
Faults

13.2 Fault table

Fault
Defective axial
strokes in the ad-
aptation clamping
device
Clamping element
cannot be
swapped in or out
Adaptation clamp-
ing element cannot
be swapped in or
out
Clamping force is
too weak
Clamping force is
too high
Geometry devia-
tion on the work-
piece
86
Possible cause Remedial action
Remove and clean the clamping
Dirt in the parts in element and, if necessary, re-
the power flow move, dismantle and clean the ad-
aptation clamping device
Check the coupling position and
Incorrect coupling
align with the adaptation clamping
position
device
Defective axial
See fault »Defective axial strokes
strokes in the ad-
in the adaptation clamping de-
aptation clamping
vice«
device
Defective axial
See operating instructions for the
strokes in the basic
basic clamping device
clamping device
Workpiece outside
the clamping width Use a suitable clamping element
diameter
Axial actuation Check machine setting and cor-
force is too weak rect if necessary
Stroke limitation by
Use an appropriate workpiece
the workpiece end-
end-stop
stop
Coupling ring Install a suitable workpiece end-
works loose stop
Axial actuating Check machine setting and cor-
force is too high rect if necessary
Check axial run-out of the adapta-
Axial run-out error
tion clamping device and clean the
on the adaptation
mating surfaces and locating taper
clamping device
if necessary
Check face run-out of the adapta-
Face run-out error
tion clamping device and clean the
on the adaptation
mating surfaces and locating taper
clamping device
if necessary
Remove the workpiece end-stop
Dirty end-stop area
and clean the mating surfaces
Dirty coupling area Remove the clamping element,
in the clamping el- clean the coupling area and the
ement clamping element
Order hotline +49 7144.907-333
Remedied by
Skilled special-
ist
Skilled special-
ist
Skilled special-
ist
Skilled special-
ist