Table of Contents
Advertisement
Quick change-over system centroteX S
Faults
13 Faults
13.1 Procedure with faults
13.2 Fault table
Fault
Incorrect axial
strokes in the
quick change-over
system
The following chapter describes possible causes for faults,
and the work involved in remedial action.
If multiple faults occur, shorten the maintenance intervals in
accordance with actual load levels.
Contact the manufacturer if faults occur that cannot be rem-
edied by following these instructions [see »Contact« chap-
ter].
This applies in all cases:
1.
With faults that constitute an immediate danger to peo-
ple or capital equipment, press the Emergency Stop but-
ton on the machine tool immediately.
2.
Establish the cause of the fault.
3.
If troubleshooting requires work to be conducted in the
danger area, switch the machine tool into set-up mode.
4.
Notify the person on location of the fault immediately.
5.
Depending on the type of fault, get it remedied by au-
thorized and appropriately skilled specialists.
INFORMATION
The troubleshooting table in the following section pro-
vides information about who is authorized to remedy
a given fault.
6.
In the event of a fault not caused by the product, the fault
may be caused by something close to the machine tool.
For this, refer to the operating instructions of the ma-
chine tool.
Possible cause
Remedial action
Dismantle and clean the quick
Dirt in the parts in
change-over system. If necessary,
the power flow
remove, dismantle and clean the
quick change-over system
Defective drawtube
Discussion with the manufacturer
adapter
The set-up dimen-
Check the set-up dimension and
sion was not main-
correct if necessary
tained
Check position of drawtube and
Incorrect drawtube
align with that of the quick
position
change-over system
Order hotline +49 7144.907-333
Remedied by
Skilled special-
ist
Manufacturer
Skilled special-
ist
79
Advertisement
Table of Contents
