Fault Table; Commissioning After A Fault Has Been Remedied - Hainbuch centroteX M Operating Instructions Manual

Quick change-over system centroteX M
Faults

13.2 Fault table

Fault
Incorrect axial
strokes in the
quick change-over
system
Clamping force is
too weak
Clamping force is
too high
Geometry
deviation on the
workpiece
It is no longer pos-
sible to install the
quick change-over
unit / quick
change-over
adapter
It is difficult to take
down the quick
change-over unit /
quick change-over
adapter

13.3 Commissioning after a fault has been remedied

56
Possible cause Remedial action
Remove and clean the quick
Dirt in the compo- change-over unit / quick change-
nents in the power over adapter. If necessary, re-
flow move, dismantle and clean the
machine adapter
The set-up dimen-
Check the set-up dimension and
sion was not main-
correct if necessary
tained
See fault table on machine
Axial actuation
adapter [see operating instructions
force is too weak
for the machine adapter]
See fault table on machine
Axial actuating
adapter [see operating instructions
force is too high
for the machine adapter]
Check the concentricity of the
Concentricity error
quick change-over system and the
on the clamping
clamping device, and correct if
device
necessary
Check top run-out on the quick
Top run-out error
change-over system and the
on the clamping
clamping device and, if required,
device
clean their mating surfaces
Defective axial
strokes in the quick See fault »Incorrect axial strokes
change-over sys- in the quick change-over system«
tem
Use force to release the quick
Dirt on the quick- change-over unit / quick change-
release screws over adapter and clean the quick-
release screws
Table 7: Fault table
After the fault has been remedied, perform the following
steps to recommission it:
1. Reset the emergency stop equipment.
2. Acknowledge the fault on the control unit of the machine
tool.
3. Ensure that no-one is in the danger area.
4. Start the machine tool.
Order hotline +49 7144.907-333
Remedied by
Skilled special-
ist
Skilled special-
ist
Skilled special-
ist
Skilled special-
ist
Skilled special-
ist
Skilled special-
ist