Fault Table - Hainbuch B-Top3 Operating Instructions Manual

B-Top3
Faults

13.2 Fault table

Fault
Incorrect axial
strokes in the
clamping device
Clamping element
cannot be
swapped in or out
Clamping force is
too weak
Clamping force is
too high
Geometry devia-
tion on the work-
piece
86
Possible cause Remedial action
Remove and clean the clamping
Dirt in the parts in elements, and remove, dismantle
the power flow and clean the clamping device if
necessary
Defective drawtube
Discussion with the manufacturer
adapter
Incorrect drawtube Check drawtube position and align
position with the clamping device
Defective axial
See fault »Defective axial strokes
strokes in the
in the clamping device«
clamping device
Workpiece outside
the clamping width Use a suitable clamping element
diameter
Axial actuating
Check machine setting and cor-
force on drawtube
rect if necessary
too weak
Incorrect lubrica- Check lubrication of the clamping
tion condition device and correct if necessary
Axial actuating
Check machine setting and cor-
force on drawtube
rect if necessary
too high
Concentricity error Check axial run-out of the clamp-
on the clamping ing device and correct if neces-
device sary
Face run-out error Check face run-out of the clamp-
of the clamping de- ing device and clean the mating
vice surfaces if necessary
Clamping elements Check the gap dimension
installed incorrectly and correct if necessary
Dirty locating area Remove the clamping elements;
on the clamping el- clean the coupling area and the
ement clamping element
Geometry error on
the workpiece due
Use a suitable clamping element
to incorrect type of
clamping element
Reduce the clamping force to the
Elastic distortion level applicable for the clamping
device and the workpiece
Order hotline +49 7144.907-333
Remedied by
Skilled specia-
list
Manufacturer
Skilled specia-
list
Skilled specia-
list
Skilled specia-
list
Skilled specia-
list