Table of Contents
Advertisement
Face driver adaption
Faults
13 Faults
13.1 Procedure with faults
13.2 Fault table
Fault
Defective axial
strokes in the ad-
aptation clamping
device
Adaptation
clamping device
cannot be
swapped in / out
The following chapter describes possible causes for faults,
and the work involved in remedial action.
If multiple faults occur, shorten the maintenance intervals in
accordance with actual load levels.
Contact the manufacturer if faults occur that cannot be rem-
edied by following these instructions [see »Contact« chap-
ter].
This applies in all cases:
1.
With faults that constitute an immediate danger to peo-
ple or capital equipment, press the Emergency Stop but-
ton on the machine tool immediately.
2.
Establish the cause of the fault.
3.
If troubleshooting requires work to be conducted in the
danger area, switch the machine tool into set-up mode.
4.
Notify the person on location of the fault immediately.
5.
Depending on the type of fault, get it remedied by au-
thorized and appropriately skilled specialists.
INFORMATION
The troubleshooting table in the following section pro-
vides information about who is authorized to remedy
a given fault.
6.
In the event of a fault not caused by the product, the fault
may be caused by something close to the machine tool.
For this, refer to the operating instructions of the ma-
chine tool.
Possible cause
Remedial action
Dirt in the parts in
Remove the adaptation clamping
the power flow
device and clean it
Dirt in the spring
Remove, disassemble and clean
chamber
the adaptation clamping device
Springs fatigued
Replace the springs
Defective axial
See operating instructions for the
strokes in the basic
basic clamping device
clamping device
Order hotline +49 7144.907-333
Remedied by
Skilled special-
ist
HAINBUCH
55
Advertisement
Table of Contents
