Fault Table - Hainbuch centroteX M Operating Instructions Manual

Quick change-over system centroteX M
Faults

13.2 Fault table

Fault
Incorrect axial
strokes in the
quick change-over
system
It is no longer pos-
sible to install the
quick change-over
unit / quick
change-over
adapter
It is difficult to take
down the quick
change-over unit /
quick change-over
adapter
Clamping force is
too weak
Clamping force is
too high
Geometry devia-
tion on the work-
piece
Indentations on
the clamping
surface
Possible cause Remedial action
Remove and clean the quick
Dirt in the compo- change-over unit / quick change-
nents in the power- over adapter. If necessary, re-
flow move, dismantle and clean the
machine adapter
Defective drawtube Consultation with the manufac-
adapter turer
The set-up dimen-
Check the set-up dimension and
sion was not main-
correct if necessary
tained
Check drawtube position and
Incorrect drawtube
compare against the quick
position
change-over system
Defective axial
strokes in the quick See fault »Incorrect axial strokes
change-over sys- in the quick change-over system«
tem
Use force to release the quick
Dirt on the quick- change-over unit / quick change-
release screws over adapter and clean the quick-
release screws
Axial actuating
Check machine setting and cor-
force on drawtube
rect if necessary
too weak
Axial actuating
Check machine setting and cor-
force on drawtube
rect if necessary
too high
Axial run-out error
Check axial run-out on the quick
on the quick
change-over system and correct if
change-over sys-
necessary
tem
Face run-out error
Check face run-out on the quick
on the quick
change-over system and, if neces-
change-over sys-
sary, clean the locating surfaces
tem
Remove and clean the quick
Dirt on the CEN- change-over unit / quick change-
TREX support over adapter and the CENTREX
support
Order hotline +49 7144.907-333
Remedied by
Skilled special-
ist
Manufacturer
Skilled special-
ist
Skilled special-
ist
Skilled special-
ist
Skilled special-
ist
Skilled special-
ist
Skilled special-
ist
69