Dell EMC Edge Gateway 5200 User Manual page 39

Table 26. Console Redirection COM1 (continued)
Parameter
Flow Control
VT-UTF8 Combo Key Support Disabled, Enabled
Recorder Mode
Resolution 100x31
Putty KeyPad
Figure 34. Console Redirection COM(Pci Bus0,Dev22,Func3)
Table 27. Console Redirection COM(Pci Bus0,Dev22,Func3)
Parameter
Terminal Type
Settings
None, Hardware RTS/CTS
Disabled, Enabled
Disabled, Enabled
VT100, LINUX, XTERMR6,
SCO, ESCN, VT400
Settings
VT100, VT100+, VT-UTF8,
ANSI
Description
Flow control can prevent data loss from buffer overflow.
When sending data, if the receiving buffers are full, a stop
signal can be sent to stop the data flow. Once the buffers are
empty, a start signal can be sent to restart the flow. Hardware
flow control uses two wires to send start/stop.
Enable VT-UTF8 Combination Key Support for ANSI/VT100
terminals.
With this mode enabled, only text is sent. This is to capture
terminal data.
Enables or disables extended terminal resolution.
Select FunctionKey and KeyPad on Putty.
Description
Emulation: ANSI: Extended ASCII character set. VT100: ASCII
character set. VT100+: Extends VT100 to support color,
BIOS Setup 39