Table of Contents
Advertisement
3
3
I
NITIAL
C
ONFIGURATION
B
P
AND
OOT
HASES
P
ERFORMING
M
ULTIPOINT
Setting Ethernet Speed and Duplex Parameters
"
Setting the IP Address for Both Blades
"
Initial Configuration and Boot Phases
"
Changing the Global User Name and Password
"
Initial monitoring and administration of the LifeSize Multipoint are performed
from a remote PC via a serial connection using a terminal emulation application,
such as HyperTerminal. This allows you to access the boot configuration menu of
the LifeSize Multipoint. At power-up, the LifeSize Multipoint goes through the
following boot phases:
Auto-boot—The embedded operating system initializes and displays
"
basic information.
Configuration menu—A 10-second countdown allows you to enter the
"
configuration menu.
Initialization—The LifeSize Multipoint completes its boot sequence and
"
is ready for operation.
You can perform serial port configuration of the LifeSize Multipoint only
Note
at startup, during a short period indicated by a 10-second countdown. Once the
initialization phase is complete, the only way you can access the configuration
menu is by restarting the LifeSize Multipoint.
I
L
NITIAL
230 C
ONFIGURATION
Performing Initial LifeSize Multipoint 230 Configuration
S
IFE
IZE
on page 18
on page 16
on page 15
on page 19
15
Advertisement
Table of Contents
