Changing The Global User Name And Password - LifeSize Multipoint 230 Installation Manual

C
HANGING THE
G U
LOBAL SER
N
AME AND
P
ASSWORD
#!
Enter the appropriate number or letter at the prompt for one of these
5
options:
1 - 100Mbps Half Duplex
$
2 - 100Mbps Full Duplex
$
3 - 1Gbps Full Duplex
$
4 - Auto Negotiation
$
Other - Quit
$
We recommend that you select "4 - Auto Negotiation".
Note
Press Enter.
6
The network configuration Main menu appears.
Do one of the following:
7
Enter the letter for the set of parameters that you want to configure.
$
Enter Q to save your changes and allow the device to complete the
$
boot process.
You can change the global user name and password that the LifeSize Multipoint
uses. You use this user name and password to access the configuration web page
for the LifeSize Multipoint. The user name and password are required for these
tasks:
Starting a Telnet session to monitor the LifeSize Multipoint
"
Upgrading the LifeSize Multipoint software
"
Uploading Interactive Voice Response (IVR) messages to LifeSize
"
Multipoint configuration memory
The default global user name is admin. The default password is password.
Procedure
Start a terminal emulator session as described in the
1
Address for Both Blades
Enter P at the prompt.
2
Enter the name that you want to use as the global user name at the Enter
3
User name prompt, and press Enter.

Changing the Global User Name and Password

on page 16.
Performing Initial LifeSize Multipoint 230 Configuration
Setting the IP
19