Table of Contents
Advertisement
Keypad Remote Mounting using the ASD-MTG-KIT
Note:
See
Figures 23
through 6.
1.
At the keypad mounting location, identify and mark the locations of the 5.00" by 4.60" hole and the
four 0.34" screw holes.
2.
Cut the 5.00" by 4.60" rectangular hole.
3.
Drill the four 0.34" holes.
4.
Attach and secure the Bezel plate to the front side of the mounting location using the four 10-32
hex nuts, #10 split lock washers, and the #10 flat washers.
5.
Attach and secure the keypad to the front side of the Bezel plate using the four 6-32 x 5/16" pan
head screws, #6 split lock washers, and the #6 flat washers.
6.
Connect the RJ-45 extension cable(s).
Keypad ASD-MTG-KIT Dimensions (mounting)
Figure 23. Keypad Bezel Plate Mounting Dimensions.
Figure 24. Screw Length Precaution.
CAUTION: Failure to use the correct hardware may result in damage to the outer surface of the EOI panel
and/or improper seating of the panel to the bezel plate. Use caution when mounting the EOI assembly to ensure
that the internal thread clearance is maintained.
Correct
HX7+ ASD Installation and Operation Manual
and
24
for the dimensions and the item locations referenced in steps
1
Incorrect
43
Advertisement
Table of Contents
