Table of Contents
Advertisement
F152
FL On Delay
Program Terminal Selection Out Terminal Delays
This parameter delays the closing of the FL output terminals by the
programmed value (see waveforms at F150).
The delay may be increased to prevent relay chatter.
OUT4 On Delay
Program Terminal Selection Out Terminal Delays
This parameter delays the closing of the OUT4 output terminals by the
programmed value (see waveforms at F150).
The delay may be increased to prevent relay chatter.
OUT5 On Delay
Program Terminal Selection Out Terminal Delays
This parameter delays the closing of the OUT5 output terminals by the
programmed value (see waveforms at F150).
The delay may be increased to prevent relay chatter.
OUT6 On Delay
Program Terminal Selection Out Terminal Delays
This parameter delays the closing of the OUT6 output terminals by the
programmed value (see waveforms at F150).
The delay may be increased to prevent relay chatter.
OUT7 On Delay
Program Terminal Selection Out Terminal Delays
This parameter delays the closing of the OUT7 output terminals by the
programmed value (see waveforms at F150).
The delay may be increased to prevent relay chatter.
92
Direct Access Number — F152
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
Direct Access Number — F153
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
Direct Access Number — F154
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
Direct Access Number — F155
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
Direct Access Number — F156
Parameter Type — Numerical
Factory Default — 2.0
Changeable During Run — No
Minimum — 2.0
Maximum — 200.0
Units — mS
HX7+ ASD Installation and Operation Manual
F156
Advertisement
Table of Contents
