Table of Contents
Advertisement
Table 15
shows the output selections for the AM, FM, FP, and Analog 1 & 2 terminals. The magnitude
of the AM and FM output signals at full-scale is selection-specific and may be adjusted (see
F006) to fit application-specific requirements.
The column on the right side of
100%.
Table 15. Output terminal selections for the AM, FM, FP, and Analog 1 & 2 terminals.
Output Frequency (FM and FP default setting)
Frequency Reference
Output Current (AM default setting)
DC Bus Voltage
Output Voltage (Analog 1 default setting)
Post-compensation Frequency (Analog 2 default setting)
Speed Feedback (realtime)
Speed Feedback (1 sec filter)
Torque
Torque Command
Internal Torque Base
Torque Current
Excitation Current
PID Feedback Value
Motor Overload Ratio
ASD Overload Ratio
PBR (DBR) Overload Ratio
PBR (DBR) Load Ratio
Input Power
Output Power
Peak Output Current
Peak DC Bus Voltage
PG Counter
Position Pulse
RR Input
VI/II Input
RX Input
RX2 Input
FM Output (used for factory testing only)
AM Output (used for factory testing only)
Meter Adjust Value
Analog Output
Load Torque
HX7+ ASD Installation and Operation Manual
Table 15
shows the actual AM and FM outputs for a keypad display of
Function
AM/FM Output Value at 100%
Keypad-Displayed Output
Maximum Frequency
150%
Maximum Frequency
150%
Maximum Frequency
Motor Overload Trip-Point Setting
ASD Overload Trip-Point Setting
DBR Overload Trip Point Setting
Maximum DBR Duty Cycle
1.73 * input voltage * ASD rated current
150%
32767 Encoder Pulses
100%
150%
and
F671
193
Advertisement
Table of Contents
