Table of Contents
Advertisement
Startup Wizard Requirements
The
Startup Wizard
for information on the frequently used ASD control settings and system operational specifications. The
HX7+ ASD may also be setup by directly accessing each of the settings via the Program menu or the
Direct Access Number for each item (see the section titled
72
for specifics on each parameter). Application-specific settings may still be required upon completion.
The Startup Wizard is launched from the Program menu.
Input the required information into the following screens to complete the Startup Wizard.
Select the input power specifications or click Manually Configure- Finish to exit.
Click Next or Finish after each subsequent window. Next opens the next Startup Wizard window.
Finish returns the system to the
1. Voltage and Frequency Rating of the Motor
Motors are designed and manufactured for operation
within a specific voltage and frequency range. The
voltage and frequency specifications for a given
motor may be found on the nameplate of the motor.
Settings:
2 — 380v, 50Hz
3 — 460v, 60Hz
2. Upper Limit Frequency
This parameter sets the highest frequency that the
HX7+ ASD will accept as a frequency command or
frequency setpoint. The HX7+ ASD may output
frequencies greater than the Upper Limit
Frequency (but, less than the Maximum Frequency)
when operating in the PID Control mode, Torque
Control mode, or the Vector Control modes
(sensorless or feedback).
3. Lower Limit Frequency
This parameter sets the lowest frequency that the
HX7+ ASD will accept as a frequency command or
frequency setpoint. The HX7+ ASD will output
frequencies lower than the Lower Limit Frequency
when accelerating to the lower limit or decelerating
to a stop. Frequencies below the Lower Limit may
also be output when operating in the PID Control
mode, Torque Control mode, or the Vector Control
modes (sensorless or feedback).
HX7+ ASD Installation and Operation Manual
assists the user with the initial configuration of the HX7+ ASD by querying the user
Frequency Command
Direct Access Parameter Information on pg.
screen.
53
Advertisement
Table of Contents
