2N Indoor View User Manual page 26

Dynamic IP Address Setting
Follow the instructions below to switch on the Static IP address mode (DCHP ON):
• Press and hold the RESET button.
• Wait until the red and green LEDs go on simultaneously on the device and the acoustic
signal can be heard
• Wait until the red LED goes off and the acoustic signal can be heard
another 3 s).
• Wait until the green LED goes off and the red LED goes on again and the acoustic signal
can be heard
• Release the RESET button.
Factory Reset
Follow the instructions below to reset the factory default values:
• Press and hold the RESET button.
• Wait until the red and green LEDs go on simultaneously and the
heard (approx. 15–35 s).
• Wait until the red LED goes off and the
another 3 s).
• Wait until the green LED goes off and the red LED goes on again and
can be heard (approx. for another 3 s).
• Wait until the red LED goes off and the
another 3 s).
• Release the RESET button.
(approx. 15–35 s).
(approx. for another 3 s).
acoustic signal
acoustic signal
2N® Indoor View User Manual
(approx. for
acoustic signal can be
can be heard (approx. for
acoustic signal
can be heard (approx. for
26 / 110