Table of Contents
Advertisement
9 Installing the cabinet on a Concrete Pedestal
When no battery compartment is configured for the cabinet
Step 1: Open and fasten the door of the cabinet.
Support lever
The installation holes
Install the protection fence.
Unit: mm
800~1000
Support lever
Step 3: Remove the AC PDU, and
remove the waterproof plugs from
the installation holes.
M12 × 60
expansion
bolt
800~1000
21
Step 2: Loosen the 4 captive screws on the cover
of the AC PDU to remove the cover and properly
keep the cover.
Step 4: Fasten the cabinet by using
the socket ring wrench to fasten the
M12 × 60 Expansion bolts (hole
which is on the left and rear side of
cabinet
waterproof glue on the bottom of the
cabinet and the concrete pedestal
surfaces that contacts the cabinet.
• Construct the protection fence after
installing the cabinet.
• Plan the coverage of the protection fence
based on the ground plan to ensure that all
doors of the cabinet can be opened without
difficulties.
can be left empty. Apply
Advertisement
Table of Contents
