Table of Contents
Advertisement
Chapter 3
Initial Setup and Mode Main
Mode Menu
Sets Master
Security Code
DIP switch position 2 must be On (master code enable).
3–4
Access the Mode Menu by pressing the [MODE] key. All other functions are
halted when the menu is displayed.
Note: DIP switch SW-3 must be in the On position or the [MODE] key will
not function.
The Mode Menu provides access to four functions:
Select a menu item by pressing the corresponding numeric key [1] ! [4].
The menu structure is shown below:
Resets the DTAM Micro
1 Baud Rate
3 Parity
2 Data Bits
4 Exit
Configures DTAM Micro
Communications Port
1 Master
2 Scale
Enables / Disables
Performs
Scaling
Functional Tests
1 Reset
3 Special
2 Com-Port
4 Other
1 Reset
3 Special
2 Com-Port
4 Other
1 P-A/D
2 Mode
3 Simulate
4 Test
5 Ex
Simulates Controller
Exits to
Mode Menu
SLC or 50X Address
1 = Edit Addr
0 = Bypass
(Only with DH485
Operating System)
3 Mem Xfer
4 Clr Fault
Special
Controller Operations
Communications
Advertisement
Table of Contents
