Advertisement
40. At this point the wings should
look like this.
42. Glue to the leading the upper and lower balsa
sheet B21. For this use a PVA type glue and pins to
hold them in place as the glue dries.. Ensure the
wings stay flat during the process.
44. Glue in place the reinforcing parts B16.
Page 11
41. Glue to the front of the spar at the root the
separate front part of rib B1. Then add the front
wing dowel plate B11 and the half rib B12.
43. Add 2 pieces of 6x8mm hardwood to the servo
bay area as shown above.
Advertisement
