Advertisement
45. Add the top trailing edge sheeting B23 and the
rib capping strips B24. The capping strips are glued
to the top and bottom of the wing ribs in between
the leading edge and trailing edge sheeting.
47. Using parts B17 and B18 construct the wing
servo mount. These are also the wing float
mounts, see further on in the manual.
49. Laminate 2 off B20 8mm balsa sheet together and
glue to each wing tip.
46. Glue into place the leading edge B15. When the glue has
dried sand to the profile shown.
48. Sand the trailing edge of the wings then
glue 2mm balsa strips to the trailing edge.
50. Sand the wing tips to shape as shown. At this
point the rest of the wing can be sanded as well to
smooth out the joints.
Page 12
Advertisement
