Advertisement
Rudder.
65. Glue parts D4/D5/D6
and D7 to form the frame of
the rudder.
Horizontal Stabilizer.
69. Build the outer frame using parts
D1/D2/D3 and D9.
71. Trial fit the vertical stabilizer to the rear of the fuselage, adjust the fit by sanding or trimming
as necessary. When satisfied with the fit glue into position, ensure it stays vertical to the fuselage
as the the glue dries. Once this has set add the rear skid/reinforcement part D8 as shown.
66. Add the horizontal
braces D12 and D13.
Page 16
67. Mark the leading edge
of the rudder with a V as
shown above for the hinge
line.
70. Add the horizontal braces D10 and D11.
68. Sand or plane the
edges of the rudder in a V
to form the hinge line.
Advertisement
