Advertisement
28. Glue a pair of magnets to the battery
hatch part A14.
The basic fuselage is now finished, sand the entire assembly and smooth and round
off the corners.
Wing Assembly. (Build the 2 wings on a flat surface to avoid any twisting)
30. Laminate together the root ribs B1/B2 and B3.
Note: B1 has a front piece which is added later.
32. Add the vertical webbing B10 to the front 2
spars from underneath.
29. Glue another pair of magnets to the corresponding
part of the fuselage where the battery hatch fits. Ensure
the polarity of the magnets are correct so that they
attract and not repel.
31. Position and glue to the 2 off 6x8mm main spars,
wing ribs B4 and B5, B5 are the center ribs. Also add
the rear spars B7 and B8.
33. Add the root rib assembly that you laminated
at step 30.
Page 9
Advertisement
