Advertisement
34. Glue the reinforcing ribs B6 to the insides of ribs
B5 so that they face each other.
36. Sand another B9 balsa block to a taper and
glue in between the root rib B1 and the B4 rib next
to it.
38. Glue B13 into position ensuring the hole for the
front wing dowel is nearer the bottom than the top.
35. Add the lower trailing edge sheeting to underneath
the rear of the wing ribs. Sand the B9 balsa blocks to a
taper and glue in between the rear of ribs B6.
37. Trim the front of each rib just in front of the
spar to fit the vertical webbing B13.
39. Add the leading edge B14 to the ribs as shown
above.
Page 10
Advertisement
