Advertisement
72. Mark the leading edge of the elevators
with a V as shown above for the hinge line.
74. Hinge the elevators but do not glue the
hinges in place. Pass the elevator U shaped
metal joiner through the gap behind the
horizontal stabilizer and position it evenly on
the elevators. Mark the position ready for
drilling the holes.
76. Replace the elevators onto the joiner and the hinges but do not glue. Fit the hinges
to the rudder/vertical stabilizer but do not glue these either. The hinges will be glued in
place once the model has been covered with film.
73. Sand or plane the edges of the elevators
in a V to form the hinge line.
75. Drill the holes on the hinge line of the
elevators to accept the U shaped metal
joiner.
Page 17
Advertisement
