Advertisement
90. Your Seagull Seaplane basic construction is finished, check it over and give it a final sanding
where necessary. If you plan to fly it off of water then we recommend that you seal around all
the glue joints with a waterproof sealer before covering.
91. Cover with a good quality covering film the separate components. These are the fuselage and
tail parts, wings, ailerons, elevators and rudder.
92. Hinge the ailerons, elevators and rudder.
93. Attach to the control surfaces suitable control horns.
94. Install the motor, ESC, servos and push rods. If you are a relative newcomer to RC modeling
then enlist the help of an inexperienced modeler to help finish the Seagull off.
1. Wing incidence: 1.5 degrees positive.
2. Tail incidence: 0 degrees.
3. Center of gravity (balance point): Between 20~30% of the wing chord
measured at the root.
Important Data:
Page 20
Advertisement
