Cabling Watchport; Watchport Camera Products; Watchport Sensor Products - Digi Inside Out Watchport Installation Manual

Monitoring appliances

Hide thumbs

Table Of Contents

Table of Contents

USB Type A Connector

To connect your Watchport/V2, plug the Type A (flat) end of the USB cable into the USB port

located in the back of your PC or into an available USB port on a standard hub or into an Inside

Out Networks Hubport. Plug the Type B (rounded) end of the USB cable into the Watchport/V2.

The sensing device of the Watchport Sensor Products comes with an RJ45 terminated cable.

Plug the RJ45 connector into the corresponding jack on the Watchport base unit.

Plug the Type A (flat) end of the USB cable into the USB port located in the back of your PC or

into an available USB port on a standard hub or into an Inside Out Networks Hubport

Type B (rounded) end of the USB cable into the Watchport base unit.

Watchport Sensor products, which are

shipped with a 6 foot cable, can be

extended using a CAT-5 twisted pair cable

up to 500 feet for the Watchport/A,

Watchport/H, Watchport/P and Watchport/T

and 1000 feet for the Watchport/W. Contact

Inside Out Networks if you need to extend it

beyond these limits.

To extend your cable, we recommend that

you use CAT-5 twisted pair cable and follow

the wiring in Table 1 above. Your color

assignment may vary and you will need to

adjust the tables accordingly. Connect only

the actively used signals indicated in the

wiring diagram below.

If you need to shorten the cable, cut off the

RJ45 connector and crimp a new connector

at the end following the wiring in Table 2

(for all sensors).

Watchport Installation Guide (90000406 Rev. D) – Page 6