Updating Base Unit Firmware
This section applies to Watchport Sensor base units only (not Watchport Camera products).
1) Connect the Watchport base unit to your PC. Refer to "Cabling Watchport" on page 6 for
information on connecting your Watchport base unit.
2) Open the Edgeport configuration utility program, found in the Start/Programs menu.
3) In the General tab, click on Update.
4) The Open button allows you to browse for the Watchport firmware (*.rom). The Edgeport
Utility program can detect if the firmware is the same version, an older version, or for a
different sensor.
5) After clicking Update, you will always be asked to confirm that you want to update your
firmware. NOTE: Do NOT disconnect your Watchport until the update is complete!
6) After clicking OK, the update is complete.
See "The Edgeport Utility Program" on page 16 for more information about using this feature.
Watchport Installation Guide (90000406 Rev. D) – Page 8