Table of Contents
Advertisement
Note
Attach an ATX power cable to the SATA hard drive.
3. Attach Power
Plug the power adapter cable CBR-2022 into connector J6. Attach the motherboard
connector of the ATX power supply to the adapter.
4. Soft Power Button Configuration
The EBX-22 requires activation of the soft power button to power up. This can be
executed manually or automatically. Installing a jumper on pins V5[1-2] causes the EBX-
22 to create its own soft power pulse automatically when power is applied. If a jumper is
installed at V5[3-4], you will have to create a pulse on pin 40 of I/O connector J14. This
can be done by shorting pin 40 to ground for 100 to 500 ms.
5. Review Configuration
Before you power up the system, double check all the connections. Make sure all cables
are oriented correctly and that adequate power will be supplied to the EBX-22 and
peripheral devices.
Verify that jumper V1[1-2] is installed. This connects the battery to the 32 kHz clock and
CMOS. The board will not turn on with out this connection.
6. Power On
Turn on the ATX power supply and the video monitor. If the system is correctly
configured, a video signal should be present.
7. Select a Boot Drive
During startup, press the B key to display the boot menu. Insert the OS installation CD in
the CD-ROM drive, and select to boot from the CD-ROM drive.
8. Install Operating System
Install the operating system according to the instructions provided by the OS
manufacturer. (See Operating System Installation.)
Note
If you intend to operate the EBX-22 under Windows XP or Windows XP
Embedded, be sure to use Service Pack 2 (SP2) and all updates for full support of
the latest hardware features.
EBX-22 Reference Manual
The mating connector on some SATA data cables may interfere with the
proper seating of a PC/104-Plus (PCI) expansion board at connector J17.
The SATA specification does not specify exterior dimensions for
connector housings, and some manufacturers make wider housings than
others. The 3M 5602 Series straight SATA connector is 0.22 in. wide and
will interfere less with the PC/104-Plus card. Even with thinner SATA
cables, you may need to ease the cable(s) away from the PC/104-Plus
connector to seat the expansion board completely.
Configuration and Setup
10
Advertisement
Table of Contents
