Compactflash; Installing An Operating System On Compactflash - VersaLogic EBX-22 Reference Manual

CompactFlash

Connector J20 provides a socket for a Type I or Type II CompactFlash (CF) module. This IDE
based interface operates on the same channel than the IDE interface at connector J22. The CF
interface supports operation in DMA mode.
The following CF modules have been tested and qualified as bootable devices by VersaLogic.
Part numbers with a suffix of -3500 are RoHS-compliant.
I O
NSTALLING AN
Installing an operating system to a CF module is best performed using a USB CD-ROM drive.
1. Remove the jumper installed at V6[1-2]. Removing the jumper designates the CF as the
slave IDE device. (Note: If you use an IDE CD-ROM drive instead of a USB drive, the
CD-ROM drive must be the master and the CF the slave.)
Boot from the CD-ROM drive. (During the early boot cycle, press the B key to access the
2.
boot menu, and select the drive.)
3. Install the OS.
After installing the OS, you may configure the CF to be the first boot device, which will
reduce boot time.
EBX-22 Reference Manual
Table 15. Qualified Bootable CF Modules
Manufacturer Density
Hagiwara 1 GB
Hagiwara 512 MB
Silicon Systems 128 MB
Silicon Systems 128 MB
Silicon Systems 256 MB
Silicon Systems 256 MB
Silicon Systems 256 MB
Silicon Systems 256 MB
Silicon Systems 512 MB
Silicon Systems 512 MB
Silicon Systems 512 MB
Silicon Systems 512 MB
Silicon Systems 1 GB
Silicon Systems 1 GB
Silicon Systems 2 GB
Silicon Systems 2 GB
Silicon Systems 2 GB
Silicon Systems 4 GB
S C
PERATING YSTEM ON OMPACT
Interfaces and Connectors
Mfg Part Number
CF1-1GMDG(H00AA)
CF1-512MDG(H00AA)
SSD-C12M-3012
SSD-C12M-3500
SSD-C25M-3012
SSD-C25MI-3012
SSD-C25M-3500
SSD-C25MI-3500
SSD-C51M-3012
SSD-C51MI-3012
SSD-C51M-3500
SSD-C51MI-3500
SSD-C01G-3012
SSD-C01G-3500
SSD-C02G-3012
SSD-C02GI-3012
SSD-C02G-3500
SSD-C04GI-3012
F
LASH
41