Pre-Installation Requirements; Storage Prior To Installation; Uncrating And Inspecting The Analyzer; Tools, Equipment, And Supplies Required To Connect And Prepare The 5100P For Operation - Ametek 5100P User Manual

Tdlas analyzer

Hide thumbs Also See for 5100P:

Table of Contents

Pre-Installation Requirements

If the analyzer is stored for any period of time prior to installation, store it in its

shipping case, in an environment where it is not subject to dripping or splash-

ing liquids, corrosive gases, high humidity, or excessive heat or cold. Recom-

mended storage conditions include:

Temperature:

Relative Humidity:

Failure to comply with these storage conditions will void your warranty.

Open the shipping and storage case the 5100P Analyzer is shipped in and

inspect the instrument for damage. If equipment is damaged, notify the carrier

and contact AMETEK Service (https://www.ametekpi.com/customersupport/

requestsupport) immediately if parts are missing or damage is found, and to

verify if damaged parts will require replacement prior to safely connecting and

operating the analyzer.

Tools, Equipment, and Supplies Required to

Connect and Prepare the 5100P for Operation

To prepare the analyzer for operation you need the following tools, equip-

ment, and supplies:

•

2-2 | 5100P TDLAS Analyzer

-20 to +50 °C (-4 to 122 °F)

<90 %

Set of open-end wrenches for fittings.

Detergent-based leak detector (Snoop® or another suitable leak detection

agent is permissible).

PN 9000-246-VE, Rev D

Table of Contents