Safety Instructions; General; Safety Instructions For Operation - Bartec SILASPZ Manual

Ex p Control unit
SILAS pz

Safety instructions

General

Safety instructions for operation

Rev. 0
We guarantee the Ex p control unit and its accessories for a period of one year
starting on the date of delivery from the Bad Mergentheim plant. This warranty
covers all parts of the delivery and is restricted to the replacement free of charge
or the repair of the defective parts in our Bad Mergentheim plant. Any packaging
delivered here should be kept where possible. If necessary, the goods should be
sent to us after written agreement. There is no entitlement to rectification at the
site of installation.
Do not dry wipe or clean devices in hazardous areas!
Do not open devices in hazardous areas.
The general statutory regulations or guidelines relating to safety at work,
accident prevention and environmental protection legislation must be
observed, e.g. the German Industrial Health and Safety Ordinance
(BetrSichV) or the applicable national ordinances.
Wear suitable clothing and footwear in view of the risk of dangerous
electrostatic charges.
Avoid exposure to heat outside the specified temperature range (see
Chapter "General technical data").
Avoid exposure to moisture.
Commissioning
Before commissioning, check that all components and documents are
available.
Inspection
Under EN/IEC 60079-17 / ГОСТ IEC 60079-17-2013, the owner of electrical
systems in hazardous areas is obliged to have them checked by a qualified
electrician to ensure that they are in a proper condition.
Maintenance
For electrical systems, the relevant installation and operating regulations
must be observed (e.g. Directive 99/92/EC, Directive 2014/34/EUEC,
BetrSichV or the nationally applicable ordinances EN/IEC 60079-14 /
ГОСТ IEC 60079-14-2013 and the DIN VDE 0100, TR TS 012/2011 series)!
Please observe the national waste disposal regulations for disposal.
Servicing
Regular servicing is not necessary if the device is operated correctly in
accordance with the installation instructions and ambient conditions.
BARTEC recommends annual servicing and inspection.
See Chapter "Maintenance and care".
A1-37S2-7D0001_pz_Manual_Exp-Control-Unit_20210923_0_en.docx
Safety
Page 11 of 88