Safety Instructions; Intended Use; Approval And Marking - Bartec PBTC-200 Operation And Installation Manual

Operation and Installation Manual PBTC-200
2

Safety Instructions

2.1

Intended Use

The junction box with electronic thermostat module PBTC is intended for use as a temperature controller in electrical trace heating
systems.
The junction box with electronic thermostat module may only be installed in trace heating systems that have been designed by trained
and qualified personnel with specific expertise and experience in explosion protection and trace heating systems.
It can be operated only with

Resistance Temperature Device Pt100

Appropriately designed over-current protection device

The self-limiting BARTEC heating cables type PSB, MSB, HSB+ or HTSB

End cap mounted on the heating pipe end

Completely filled out acceptance test report
The junction box with electronic thermostat module may only be operated with one heating cable; the maximum permissible heating
cable length must be observed.
The approval and marking of the respective heating system, the data sheet of the heating cable type and the design guide must be
observed.
For use with electrical systems, the relevant installation and operating conditions (e.g. according to ATEX Directive 2014/34/EU, EN
60079-0, EN 60079-14, EN 60079 17, EN 60079 30 2 and any other relevant national standards) must be observed. Information on
the type plate, the EU type examination certificate must be observed. Technical data on the thermostat module and in the operating
instructions must be observed.
2.2

Approval and marking

Approvals and markings of the junction box with PBTC electronic thermostat module:
Junction box with PBTC Electronic Thermostat Module
IECEx IBE 12.0031 X
IBExU 12 ATEX 1099 X
For the trace heating system used with in the junction box with electronic thermostat module is installed, the following approvals and
markings are applicable depending on the selected heating cable:
PSB-Heating system
IECEx KEM 09.0084X
KEMA 08 ATEX 0111 X
MSB-Heating system
IECEx KEM 09.0083X
KEMA 08 ATEX 0110 X
HSB+ -Heating system
IECEx CML 19.0008
CML 19 ATEX 3033
21-54C3-7D0001/- Notice: Technical data subject to change without notice.
04/2021-EHT-441168 No claims for damage arising from alternations, errors or misprints shall be allowed.
Ex eb mb [ib] [60079-30-1] IIC T4, T5 Gb
Ex tb [ib] [60079-30-1] IIIC T135°C, T95°C Db
II 2G Ex eb mb [ib] [60079-30-1] IIC T4, T5 Gb
II 2D Ex tb [ib] [60079-30-1] IIIC T135°C, T95°C Db
Ex e IIC T5,T6 Gb
Ex tb IIIC T85°C T100°C Db
II 2G Ex e IIC T5,T6 Gb
II 2D Ex tb IIIC T85°C T100°C Db
Ex e IIC T4, T3 Gb
Ex tb IIIC T130°C, T200°C Db
II 2G Ex e IIC T4, T3 Gb
II 2D Ex tb IIIC T130°C, T200°C Db
Ex e IIC T3 Gb
Ex tb IIIC T200°C Db
II 2G Ex e IIC T3 Gb
II 2D Ex tb IIIC T200°C Db
Page 4 / 45