Module Programming; For Security-Onlyprogramming, See Next Section - Directed Directechs DS3+ Installation Manual

Module programming

Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.
For Security-Only programming, see next section.
Ensure vehicle is in a safe location, and cannot move forward during programming. For
1
vehicles equipped with a manual transmission, make sure the gearshift lever is in the neutral
position.
DS3+: Connect the 12-pin main power harness to the DS3+ module FIRST.
Wait until the LED turns on solid red before proceeding to the next step.
2
DS4+: Connect the 12-pin main power harness to the DS4+ module FIRST.
The LED will turn on solid blue for 1 second to confirm Bluetooth communication.
Wait until the LED turns on solid red before proceeding to the next step.
3
Connect the remaining harnesses to the module.
Press Unlock on the OEM fob then insert key into key switch and turn on.
4
The LED will flash green.
5
Wait for the LED to turn solid green for 3 seconds then off.
Turn the key to off and remove it from the ignition barrel, when the module is successfully
6
programmed.
Pair remotes (if applicable).
7 For information on how to pair a specific remote, please refer to its corresponding owner
documentation, which can be found inside the product packaging of the complete system or
on www.directechs.com.*
DATA/Hardwired Tach Learning: When using Data Tach, it is recommended to follow the Tach
Learning procedure. However, when using a Hardwired Tach, the procedure is mandatory.
8
For more information, refer to the Tach Learning procedure section.
* Your aftermarket remote may differ from the model shown in the illustrations.
You have successfully completed the module programming sequence.
15
933.VW10 2.00.195.3 2010 Volkswagen Jetta SportWagen
©2022 VOXX•DEI LLC. All rights reserved.