Module Programming - Directed DIRECTECHS DB3 Installation Manual

Module programming

Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.
Ensure vehicle is in a safe location, and cannot move forward during programming. For
1
vehicles equipped with a manual transmission, make sure the gearshift lever is in the neutral
position.
The harnesses must be connected in this exact order:
1. Connect the 14-pin.
2. Connect the 12-pin.
2
3. Connect the 10-pin.
4. Connect the 4-pin D2D cable (if being used).
When the LED turns ON solid red, proceed with the next step.
Make sure that every key fob except one is located a minimum of 10 feet (3 meters) away
3
from the vehicle BEFORE proceeding with the following programming sequence.
4
Press the Unlock button on the OEM key fob. The LED flashes orange.
5
Insert the OEM key fob into the key port. The LED will continue flashing orange.
Depending on the transmission of the vehicle:
Manual: Press and hold the clutch pedal until the LED starts flashing green for 3 seconds,
-
then shuts OFF.
6
Automatic: Press and hold the brake pedal until the LED starts flashing green for 3
-
seconds, then shuts OFF.
The module is now programmed.
Troubleshooting:
If the LED continues flashing orange after 15 seconds at step 5, press and hold the
7
programming button until the LED starts flashing red. When you release the programming
button, the LED starts flashing orange again. Repeat step 5.
8
Remove the OEM key fob from the key port.
You have successfully completed the module programming sequence.
12
403.NISS3HT 3.17 2010 Nissan Altima (Smart Key)
©2023 Directed. All rights reserved.