Vehicle Connections - Directed Directechs DS3+ Installation Manual

Vehicle connections

The connection information listed below is specific to the 2010 Volkswagen Jetta SportWagen. Refer to "Pre-installation and application warnings" for a list of important notes.
Data harness, 8-pin white connector (H1)
Module
Conn./Pin Color Description
H1/1 Tan (Data) HS CAN 1 Low
H1/2 Tan/Black (Data) HS CAN 1 High
H1/3 Orange/Brown (Data) FT CAN 2 Low
H1/4 Orange/Green (Data) FT CAN 2 High
H1/5 Lt. Green No Connection
H1/6 Violet/Brown No Connection
H1/7 Orange/Black No Connection
H1/8 Yellow/Black No Connection
Analog input/output harness, 22-pin white connector (H2)
Module
Conn./Pin Color Description
H2/1 Lt. Green/Black No Connection
H2/2 Blue/White No Connection
H2/3 Dk. Green/Black No Connection
H2/4 Red/White (-) Trunk Output
H2/5 Brown/Black (-) Horn Output
H2/6 Brown/White No Connection
H2/7 White (+)
(+) Starter Output/Brake Activation
H2/8 Violet/Black (+) Ignition Output
H2/9 Dk. Blue/Black
(-) Ground When Armed (GWA) Output
H2/10 Lt. Blue/Black No Connection
H2/11 Brown/Red
(+) Siren Output
H2/12 Pink No Connection
H2/13 Violet No Connection
H2/14 Brown No Connection
12 933.VW10 2.00.195.3 2010 Volkswagen Jetta SportWagen
©2022 VOXX•DEI LLC. All rights reserved.
Connects To
Wire Location
data link connector, black 16 pin plug, pin 14
data link connector, black 16 pin plug, pin 6
Steering Column Module, 20 pin plug, pin 15
Steering Column Module, 20 pin plug, pin 14
No Connection
No Connection
No Connection
No Connection
Connects To
Wire Location
No Connection
No Connection
VESCM under driver dash, brown 52 pin plug, pin 7
No Connection
VESCM under driver dash, white 52 pin plug, pin 41
No Connection
[4] Steering Column Module, 20 pin plug, pin 18
VESCM under driver dash, brown 52 pin plug, pin 17
Must use two 1A diodes.
Note: Starter connection is mandatory. Diodes and brake connections
only required on vehicles where brake needs to be depressed to start.
Steering Column Module, 20 pin plug, pin 17
[5] Starter:
Steering Column Module, 20 pin plug, pin 18
Ignition:
Steering Column Module, 20 pin plug, pin 17
Must use a relay.
Must use a 1A 1N4002 or larger diode.
IMPORTANT: This connection is not required when using a THVWN1 T-
Harness.
No Connection
[2]
No Connection
No Connection
No Connection
(+/-) Wire Color Connection
data orange/brown Mandatory
data orange/black Mandatory
data orange/brown Mandatory
data orange/green Mandatory
(+/-) Wire Color Connection
- brown/red
- red/brown Optional
+ red/black or red/brown Remote Start
Only
+ black/red (functions with
ignition on only)
+ black Remote Start
Only
+ red/black or red/brown Security Only
+ black
Security Only