Connecting The Power Cable - Toshiba TH Series Instruction Manual

3.1.2 Connecting the Power Cable "ACIN"
([1] of Fig. 3.1; plug connector attached)
The power cable is used to supply the main AC power to the controller.
Item
Power supply
Power capacity
Instantaneous power
failure
Grounding
The connector is ACIN ([1] of Fig. 3.1).
The cable is not an accessory, so use the attached plug connector connected to ACIN
on the controller side to manufacture a cable.
ACIN plug connector
ACIN cable clamp
Wire
Wires are to be soldered to the connector (JL04V–6A18–10SE–EB).
TRANSPORTATION AND INSTALLATION MANUAL
Table 3.1 Power supply specifications
Single phase, AC 190 ~ 250 V, 50/60 Hz±1 Hz
TH250A (0.9 kVA)
TH350A (0.9 kVA)
TH180 (0.5 kVA)
TH350A–T (0.9 kVA)
Within half the cycle time
Grounding with grounding resistance of 100 Ω or less
Type:
JL04V–6A18–10SE–EB
Type: JL04–18CK
2
3.5 mm ~ 5.5 mm
(AWG22 ~ 20)
– 39 –
Specifications
Maker: Japan Aviation
Electronics Industry
Maker: Japan Aviation
Electronics Industry
2
STE 73995