Table of Contents
Advertisement
(c)
When the controller is mounted on the rack, the weight of the controller should be
supported with the legs of the controller. Screw holes for rack-mounting the
controller are used for securing the controller panel, and the weight of the
controller cannot be supported only with the screws.
(d)
On the front of the controller, a clearance of approx. 130 mm should be provided
for connecting the connector of the teach pendant. Even if the teach pendant is
not used, a clearance of approx. 50 mm is required for connecting a dummy plug.
TRANSPORTATION AND INSTALLATION MANUAL
Fig. 2.14 Removing upper cover
3 5
1 3 0
Fig. 2.15 Clearance of controller front side
– 31 –
STE 73995
Advertisement
Table of Contents
