Copy Of Safety Decal; Decal Location - Regency Bellavista B36XTCE Owners & Installation Manual

This is a copy of the label that accompanies each Bellavista™ B36XTCE Direct Vent Gas Fireplace. We have printed a copy of the contents here for your review.
NOTE: Regency ® units are constantly being improved. Check the label on the unit and if there is a difference, the label on the unit is the correct one.

COPY OF SAFETY DECAL

Listed/Nom: VENTED GAS FIREPLACE / FOYER AU GAZ À ÉVACUATION
Certified to/Certifi pour:
MAY BE INSTALLED IN MANUFACTURED (MOBILE) HOMES AFTER FIRST SALE.
Refer to Intertek's Directory of Building Products for detailed information.
Pour plus de détails , se reporter au Répertoire des produits de construction de Intertek.
C #: 4001172
NATURAL GAS: Model B36XTCE-NG11
Minimum supply pressure 5.0"
Manifold pressure high 3.5"
1.6"
Manifold pressure low
Orifice size # 35
Minimum input 21,500
Maximum input 31,000
Altitude 0-4500
PROPANE GAS: Model B36XTCE-LP11
11"
Minimum supply pressure
10"
Manifold pressure high
6.4"
Manifold pressure low
Orifice size # 51
Minimum input 25,000
Maximum input 31,000
0-4500
Altitude
This appliance must be installed in accordance with local codes, if any; if none, follow the National Fuel Gas Code, ANSI Z223.1, or Natural Gas and Propane Installation Code, CSA B149.1.
This appliance must be installed in accordance with the Standard CAN/CSA Z240 MH, Mobile Housing, in Canada, or with the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280, in the
United States, or when such a standard is not applicable, ANSI/NCSBCS A225.1/NFPA 501A, Manufactured Home Installations Standard or ANSI A119.2 ou NFPA 501C Standard for Recreational Vehicles
This appliance is only for use with the type of gas indicated on the rating plate and may be installed in an aftermarket, permanently located, manufactured (mobile) home where not prohibited by local codes. See
owner's manual for details. This appliance is not convertible for use with other gases, unless a certified kit is used. (Kit #578-972). Fan Part # 578-917.
Installer l'appareil selon les codes ou règlements locaux, ou, en l'absence de tels règlements, selon les codes d'installation ANSI Z223.1, National Fuel Gas Code ou CSA-B149.1 en vigueur. Installer l'appareil
selon la norme CAN/CSA-Z240, Série MM, Maison mobiles ou CAN/CSA-Z240 VC, Véhicules de camping, ou la norme 24 CFR Part 3280, Manufactured Home Construction and Safety Standard. Si ces normes
ne sont pas pertinentes, utilisez la norme ANSI/NCSBCS A225.1/NFPA 501A, Manufactured Home Installations Standard, ou ANSI A119.2 ou NFPA 501C Standard for Recreational Vehicles.
Cet appareil doit être utilisé uniquement avec le type de gaz indiqué sur la plaque signalétique. Cet appareil peut être installé dans une maison préfabriquée ou mobile (É.-U. seulement) installée à demeure
si les règlements locaux le permettent. Voir la notice de l'utilisateur pour plus de renseignements. Cet appareil ne peut pas être utilisé avec d'autres gaz sauf si une trousse de conversion certifiée est
fournie.
This vented gas fireplace heater is not for use with air filters.
FOR USE WITH GLASS DOORS CERTIFIED WITH THE APPLIANCE ONLY
For Use Only with Barrier (Part #578-005 with Vignette) or (Part #578-929 Installed with Flush Panels) Follow installation instructions.
Utiliser uniquement avec l'écran ( n ° 578-005 avec Vignette) ou ( n ° 578-929 Installation avec Panneaux Plats) Suivre les instructions d'installation.
Electrical supply/Alimentation électrique 115VAC, 1.13 A, 60Hz.
NOT FOR USE WITH SOLID FUELS. /
CANADIAN ENERGY
CSA P.4.1 Fireplace Efficiency (FE) / Efficacité énergétique des foyers (EEF) CSA P.4.1
PERFORMANCE
VERIFIED
Natural Gas / Gaz naturel 65.90%
RENDEMENT
Propane Gas / Gaz propane 65.90%
ÉNERGÉTIQUE
EP5011169
VÉRIFIÉ
Part #: 920-008a
For the State of Massachusetts, installation
and repair must be done by a plumber or
Colour: Everything black on grey except what is highlighted is printed red.
Size: File@100% 9.117''W x 6.045''H
gas fitter licensed in the Commonwealth of
Massachusetts.
Dec. 19/18 : Created Draft
Jan. 22/19: Rev A - remodeled decal and added ETL logo
For the State of Massachusetts, flexible con-
nectors shall not exceed 36 inches in length.
*Printer:Start serial sequence @ 000001
For the State of Massachusetts, the appli-
ances individual manual shut-off must be a
t-handle type valve.
The State of Massachusetts requires the
installation of a carbon monoxide alarm in
accordance with NFPA 720 and a CO alarm
with battery back up in the same room where
the gas appliance is installed.
é ANSI Z21.88-2017 • CSA-2.33-2017
CSA 2.17-2017
APPAREIL FONCTIONNANT AU GAZ NATUREL
Modèle B36XTCE-NG11
Pression d'alimentation minimale
WC/C.E. (1.25 kPa)
Pression manifold - haute
WC/C.E. (0.87 kPa)
Pression manifold - basse
WC/C.E. (0.40 kPa)
Taille de l'orifice
DMS
D bit calorifique minimal é
Btu/h (6.3 kW)
Btu/h (9.09 kW) D bit calorifique maximal é
ft/pi (0-1372 m) Altitude
APPAREIL FONCTIONNANT AU GAZ PROPANE
Modèle B36XTCE-LP11
Pression d'alimentation minimale
WC/C.E. (2.74 kPa)
Pression manifold - haute
WC/C.E. (2..49 kPa)
WC/C.E. (1.60 kPa) Pression manifold - basse
Taille de l'orifice
DMS
Btu/h (7.33 kW) D bit calorifique minimal é
Btu/h (9.09 kW) D bit calorifique maximal é
ft/pi (0-1372 m)
Altitude
NE PAS UTILISER AVEC UN COMBUSTIBLE SOLIDE.

DECAL LOCATION

Duplicate S/N
DO NOT REMOVE THIS LABEL / NE PAS ENLEVER CETTE ÉTIQUETTE
Ne pas utiliser de filtre à air avec ce foyer au gaz à évacuation.
POUR UTILISATION UNIQUEMENT AVEC LES PORTES EN VERRE CERTIFIÉES AVEC L'APPAREIL
FPI Fireplace Products International Ltd. Delta, BC, Canada
505
Serial No./ No de série
505
Minimum Clearances to Combustibles /
Dégagements minimaux par rapport aux matériaux combustibles
0" Clearance to
combustibles from /
Top, sides, bottom and rear of unit
Mantel Clearances from
D
Fireplace Opening /
C
(A) Min. 13" (330mm)
Side Wall Clearance
from Fireplace Opening /
A
B) Min. 12" (305mm)(on one side)
F
Ceiling from Top of
B
Fireplace Opening:
C) 36-3/4" (933mm)
Mantel Depth:
D) Max. 12" (304mm)
Alcove Clearances:
E) Min. Width 84" (2134mm),
E F) Max. Depth 36" (914mm)
Minimum Vent Clearances:
Horizontal Top
DOOR SEAL: Please
Horizontal Side
check that the door is
Horizontal Bottom 1-1/2" (38mm)
properly sealed
Vertical Vent
(See Instruction Manual for detailed instructions)
Made in Canada/ Fabriqué au Canada
Remove the faceplate from unit (refer to
manual) the rating plate will be attached
to a black chain as shown below.
DO NOT REMOVE DECAL FROM UNIT.
Bellavista® B36XTCE-11 Gas Fireplace
safety decal
2" (51mm)
1-1/2" (38mm)
1-1/2" (38mm)
920-008a
| 5