Horizontal Or Vertical Terminations; Rigid Pipe 4" X 6-5/8 - Regency Bellavista B36XTCE Owners & Installation Manual

installation

HORIZONTAL OR VERTICAL TERMINATIONS

RIGID PIPE 4" X 6-5/8"

(MUST USE REDUCER PART # 946-606 & 770-994 RIGID PIPE ADAPTOR)
The minimum components required for a basic horizontal termination using 4" x 6-5/8" are:
1 Rigid Pipe Adaptor (770-994)
1 Reducer (946-606)
1 90 Elbow
o
1 Wall Thimble
1 Length of pipe to suit wall thickness
1 Horizontal Termination Cap
Wall thickness is measured from the back standoffs to the inside mounting surface of termination cap. For siding other than vinyl furring strips may be used,
instead of the vinyl siding standoff, to create a level surface to mount the vent terminal. The Terminal must not be recessed into siding. Measure the wall
thickness including furring strips.
If a Vinyl Siding Standoff is required (it must be used with vinyl siding), measure to outside surface of wall without siding and add 2 inches.
Vertical
Termination
Cap
Storm Collar
Flashing
Ceiling Firestop
Pipe Length
43"
(1092 mm)
The Regency AstroCap and Regency Riser Vent terminal are certified for installations using Regency venting systems as well as any
TM
specific chimney systems listed in this manual. AstroCap
|
42
Bellavista® B36XTCE-11 Gas Fireplace
A
Vinyl Siding
Standoff (Optional)
Wall Thimble
Pipe Length
90 Elbow o
Pipe
Length
Reducer
(4" x 6-5/8" venting)
Rigid Pipe Adaptor
TM
B
Astrocap
(946-523/P)
is a proprietary trademark of Regency Fireplace Products.
ASTROCAP # 946-523/P
DIMENSIONS
11"
(279mm)
11"
(279mm)
WARNING:
Do not combine venting components from
different venting systems.
However use of the the AstroCap
Regency Riser is acceptable with all systems.
This product has been evaluated by Intertek
when using a rigid pipe adaptor and use of
any of the specific chimney systems listed in
this manual. Use of these systems with the
rigid pipe adaptor is deemed acceptable and
does not affect the Intertek WHI listing of these
components.
and
TM