Regency Bellavista B36XTCE Owners & Installation Manual page 26

installation
5. From the outside rear of the firebox, remove the intake collar
assembly. Remove the 4 - 1/4" x 1/2" screws. See Diagram 5.
Diagram 5
6. From the outside top of the firebox - remove top insulation cover
plate and insulation filling - by removing 4 screws. See Diagram 6.
Recycle cover plate and discard insulation filling, keep the 4 screws.
Diagram 6
7. From the outside top of the firebox - remove the intake cover plate
by removing the 4 - 1/4" x 1/2 " screws. See Diagram 7.
Diagram 7
Before proceeding to Step 8, inspect condition of all gaskets.
DO NOT install parts with damaged gaskets. Replace if necessary
with spare gaskets supplied.
8. From the inside of the firebox, place the exhaust assembly into
position as shown in Diagram 8 and secure with 8 - 1/4" x 1/2" screws
(Diagram 9). Ensure all screws are tight, but do not over tighten.
All 8 screws must be used.
Diagram 8
|
26
Bellavista® B36XTCE-11 Gas Fireplace
Exhaust
Assembly
Intake Collar
Assembly
9. From the outside top of the firebox, install the intake collar assembly.
Recycle cover
plate and discard
Insulation filling.
Not required when
converting to top
Diagram 10
vent.
10. From the outside rear of the firebox, install the intake cover plate with
11. Set vent restrictor accordingly - see next page.
12. From inside the firebox, re-install the baffle plate and heat
13. From inside the firebox, reinstall the top heat deflector by placing 2 screws.
14. From inside the firebox, reinstall the baffle plate by placing 4 screws
Note: Reuse existing screw holes - do not make new holes. Tighten screws.
Diagram 9
Secure with 4 - 1/4" x 1/2" screws. Ensure all screws are tight, but do not
over tighten. All 4 screws must be used.
4 - 1/4" x 1/2" screws. Ensure all screws are tight, but do not over tighten.
All 4 screws must be used.
Diagram 11
deflector - reverse steps 2 & 3.
Heat Deflector
- replace top front screw first. Leave loose - until rear screws installed.
See Diagram 3.
Baffle Plate
Diagram 13
Exhaust
Assembly
Intake Collar
Assembly
Diagram 12