Gateway 200ARC Network Manual page 89

Configuring computer settings for an access point using the
Broadcom Wireless Configuration Utility
To configure an access point network using the Broadcom Wireless
Configuration Utility:
1
With the access point highlighted in the Connect to Wireless Network dialog
box, click
2
Click to select the access point in the
Configure
3
Set the Wireless network key (WEP) settings to match those set on the
access point.
4
Make sure that the
access points are not used
5
Click
OK
. The Broadcom Wireless Configuration Utility opens.
Advanced
. The Wireless Network Properties dialog box opens.
This is a computer-to-computer (ad hoc) network; wireless
check box is not selected.
to close the Wireless Network Properties dialog box.
www.gateway.com
Creating a Wireless Access Point Network
box, then click
Available networks
83