Gateway 200ARC Network Manual page 49

7
If you are connecting to an office Ethernet network and are required to
type a static IP address and subnet mask, ask your network system
administrator for the correct values.
- OR -
If you are connecting to a home Ethernet network, have a cable or DSL
modem, and a router that automatically assigns IP addresses to computers
on the network, click
- OR -
If you are connecting to a home Ethernet network, have a cable or DSL
modem, and do not have a router, use the IP address and subnet mask
provided by your cable or DSL provider as the address for your computer.
Each computer connected to your network will need a unique, static IP
address.
- OR -
If you are connecting to a home Ethernet network, do not have a cable
or DSL modem, and do not have a router, click
then type the following values.
a
Type the IP address in the
where N is any number between 1 and 254. We suggest 1 for the first
computer on your network, 2 for the next, and so on. The number
must be unique on your network.
b
Type the subnet mask in the
255.255.255.0 for all computers.
8
Click to close the Internet Protocol (TCP/IP) Properties dialog box.
OK
9
Click to close the Local Area Connection Properties dialog box.
OK
10
Click to close the Network Connections window.
X
11
Repeat this procedure for every computer on your network.
12
After you enter the IP address on all your computers, go to
your router" on page
Configuring Windows for a Wired Network
Obtain an IP address automatically
box. Use the value 192.168.0.N
IP address
Subnet mask
47.
www.gateway.com
.
Use the following IP address
box. Use the value
"Configuring
,
43