Gateway 200ARC Network Manual page 75

5
If you are connecting to an office Ethernet network and are required to
type a static IP address and subnet mask, ask your network system
administrator for the correct values.
- OR -
If you are connecting to a home Ethernet network, have a cable or DSL
modem, and a wireless access point router that automatically assigns IP
addresses to computers on the network, click
.
automatically
- OR -
If you are connecting to a home Ethernet network, have a cable or DSL
modem, and do not have a wireless access point router, use the IP address
and subnet mask provided by your cable or DSL provider as the address
for your computer. Each computer connected to your network will need
a unique, static IP address.
- OR -
If you are connecting to a home Ethernet network, do not have a cable
or DSL modem, and do not have a wireless access point router, click
the following IP address
a
Type the IP address in the
where N is any number between 1 and 254. We suggest 1 for the first
computer on your network, 2 for the next, and so on. The number
must be unique on your network.
b
Type the subnet mask in the
255.255.255.0 for all computers.
6
Click to close the Internet Protocol (TCP/IP) Properties dialog box.
OK
7
Click to close the Local Area Connection Properties dialog box.
OK
8
Click to close the Network and Dial-up Connections window.
X
9
Repeat this procedure for every computer on your network.
10
After you enter the IP addresses on all your computers, go to
go from here" on page
Configuring Windows for a Wireless Network
, then type the following values.
box. Use the value 192.168.0.N
IP address
Subnet mask
70.
www.gateway.com
Obtain an IP address
box. Use the value
"Where to
Use
69