Gateway 200ARC Network Manual page 52

Wired Ethernet Networking
5
If you are connecting to an office Ethernet network and are required to
type a static IP address and subnet mask, ask your network system
administrator for the correct values.
- OR -
If you are connecting to a home Ethernet network, have a cable or DSL
modem, and a router that automatically assigns IP addresses to computers
on the network, click
- OR -
If you are connecting to a home Ethernet network, have a cable or DSL
modem, and do not have a router, use the IP address and subnet mask
provided by your cable or DSL provider as the address for your computer.
Each computer connected to your network will need a unique, static IP
address.
- OR -
If you are connecting to a home Ethernet network, do not have a cable
or DSL modem, and do not have a router, click
then type the following values.
a
b
6
Click
7
Click
8
Click
9
Repeat this procedure for every computer on your network.
10
After you enter the IP address on all your computers, go to
your router" on page
46
Obtain an IP address automatically
Type the IP address in the
where N is any number between 1 and 254. We suggest 1 for the first
computer on your network, 2 for the next, and so on. The number
must be unique on your network.
Type the subnet mask in the
255.255.255.0 for all computers.
to close the Internet Protocol (TCP/IP) Properties dialog box.
OK
to close the Local Area Connection Properties dialog box.
OK
to close the Network and Dial-up Connections window.
X
47.
www.gateway.com
Use the following IP address
box. Use the value 192.168.0.N
IP address
box. Use the value
Subnet mask
.
,
"Configuring